The possibilities of dimensional electron-beam processing as applied to selective sintering of oxide ceramics in the forevacuum pressure range
Статья в журнале
The paper presents the results of studies devoted to an effect of deviation and scanning parameters on the value of power density of a focused electron beam generated by a plasma electron source in the forevacuum pressure range. It is shown that the change in the beam power density does not exceed 20% with an angle of beam deviation within 20 degrees in the investigated pressure range of 6-8 pascals in air. The results of selective sintering of powder system of zirconia-alumina by an electron beam generated by a forevacuum plasma electron source are demonstrated.
Журнал:
- Journal of Physics: Conference Series
- IOP Publishing (London)
- Индексируется в Scopus
Библиографическая запись: The possibilities of dimensional electron-beam processing as applied to selective sintering of oxide ceramics in the forevacuum pressure range / I. Yu. Bakeev [et. al.] // Journal of Physics: Conference Series. – 2018. – Vol. 945. – Issue 1. – 012016. – DOI: 10.1088/1742-6596/945/1/012016
Ключевые слова:
FOREVACUUM ELECTRON-BEAM PROCESSING PLASMA ELECTRON SOURCES POWER DENSITIES PRESSURE RANGES SCANNING PARAMETERS FOCUSED ELECTRON BEAMS SINTERING OF POWDERS ZIRCONIA-ALUMINAИндексируется в: